WQI 44 CHEMICAL INJECTION ANCHOR BOLT

• Fast curing;
• Applicable in dry and humid holes;
• Does not drip (applicable in holes in the ceiling);
• Applied with standard studs and threaded rods;
• High strength and reliability fixation;
• Meets static and dynamic loads;
• Suitable for applications on solid and hollow bases (with the aid of sleeves);
• Does not create tension in the concrete, which allows for smaller distances between fixings;
• Uses sealant applicator for 300 ml and Walsywa applicator for 345 ml.

• Fixation of metallic structures in general;
• Fixation of machinery and equipment;
• Fixing railings;
• Fixing anchor bars;
• Fixing handrails, stairs, railings, and gates.

Image01: Qualifications. Solid

Image02: Hollow Base

Image03: Threaded rod

Image04: Conventional Hole

Image05: Reverse Application

Image06 Dry Hole

Image07 Humid Hole

Image01: Methods of application on solid foundations (solid concrete, solid masonry and natural stone) 1 Drill the hole with the indicated diameter and depth;

Image02: 2 Inject air to remove excess powder from the hole;

Image03: 3 Thoroughly clean the hole with the aid of a brush, blow and brush until there is no more dust;

Image04: 4 Insert the mixing nozzle into the hole and fill ¾ of the total with resin;

Image05: 5 Insert the stud with a twisting motion;

Image06 6 Wait for the curing time recommended in the table;

-

Image01: Methods of application on hollow foundations (hollow masonry) 1 Drill the hole with the indicated diameter and depth;

Image02: 2 Insert the sleeve into the hole;

Image03: 3 Fill the sleeve cavity with resin from the bottom;

Image04: 4 Insert the stud with a twisting motion;

Image05: 5 Wait for the cure time, position the element to be clamped and torque.

Image07 7 After curing, position the element to be fixed and torque.

Fixing threaded rods

*Last resin load in 30 Mpa concrete. Values obtained together with the parameters described in the respective tables. For practical applications a safety factor must be used (see page 49).

** Number of applications per tube under ideal installation conditions.

• “Handling time” is the time in which it is possible to manipulate the product after mixed;

• "Curing time" is the time when the resin "dries" completely and can receive loads;

• Pullout tests must be done 24 hours after the final curing time;
• After curing, keep at room temperature up to 40°C;
• For the ultimate tensile and shear load of threaded bars, see page 89.

• Before using the 300 ml tube, the plastic packaging must be cut below the clamp;

• Do not cut the mixing nozzle;
• Clean the hole correctly as explained in the solid base application method;
• At the time of application, the tube must have a temperature between 5°C and 40°C;
• Do not apply the product to holes drilled with a diamond hole saw. For this application, use the WQE 500 or WQE 500 Plus anchor bolts;
• Do not glue ribbed rebar with this product. For this application, use the anchor bolts WQI 44 Plus, WQE 500, WQE 600 or WQE 500 Plus;
• Any questions, please contact the technical department on

0800 105024