WQE 500 PLUS CHEMICAL INJECTION ANCHOR BOLT

• ETA International Certification;
• F 120 report for threaded bar and F 240 for rebar;
• High resistance to chemicals and bad weather;
• Applicable in dry, wet and submerged holes;
• Suitable for applications in solid concrete, solid masonry and natural stone;
• Applied with standard studs, threaded bars and rebars;
• Fastening of high strength (structural) for static and dynamic loads;
• Ideal for rebar pulls, recovery and structural reinforcement;
• Excellent results in holes made with diamond drills;
• Does not create tension in the concrete, which allows for smaller distances between fixings;
• Styrene-free formula;
• Uses specific applicator for 585 ml;
• The packaging can be reused by changing the mixing nozzle.

• Structural reinforcements;
• Structural recovery;
• Consoles;
• Pull-outs;
• Diaphragm wall;
• Fixing anchor bars;
• Fixing of stairs, railings and gates.

Image01: Qualifications. Solid

Image02: Threaded rod

Image03: Rebar

Image04: Conventional Hole

Image05: Diamond drilled Hole

Image06 Dry Hole

Image07 Humid Hole

Image08 Underwater Hole

Image09 Reverse Application

Image10 Seismic Regions

Image11 Fissured

Image01: Methods of application on solid foundations (solid concrete, solid masonry and natural stone) 1 Drill the hole with the indicated diameter and depth;

Image02: 2 Inject air to remove excess powder from the hole;

Image03: 3 Thoroughly clean the hole with the aid of a brush, blow and brush until there is no more dust;

Image04: 4 Insert the mixing nozzle into the hole and fill ¾ of the total with resin;

Image05: 5 Insert the stud with a twisting motion;

Image06 6 Wait for the curing time recommended in the table;

Image07 7 After curing, position the element to be fixed and torque.

Fixing threaded rods

Rebar fixing

*Last resin load in 30 Mpa concrete. Values obtained together with the parameters described in the respective tables. For practical applications a safety factor must be used (see page 49).

• Other values can be found in document TR029 and in certificate ETA 12/0255 of the WQE 500 Plus;

• “Handling time” is the time in which it is possible to manipulate the product after mixed;

• “Cure time” is the time when the resin “dries” completely and is able to receive loads;
• Pullout tests must be done 24 hours after the final curing time;
• After curing, keep at room temperature up to 40°C;

• Do not cut the mixing nozzle;
• Clean the hole correctly as explained in the solid base application method;
• At the time of application, the tube must have a temperature of at least 15°C;
• To design the chemical fixation, use calculation document TR029 together with ETA 12/0255;
• To design the chemical fixation in seismic regions, use the calculation document TR045 together with ETA 12/0255;
• Any questions, please contact the technical department on

0800 105024