WQE 600 CHEMICAL INJECTION ANCHOR BOLT

• Slow cure that admits small adjustments;
• Suitable for applications in solid concrete, solid masonry and natural stone;
• Applicable in dry, wet and submerged holes;
• Applied with standard studs, threaded bars and rebars;
• Fastening of high strength (structural) for static and dynamic loads;
• Can be applied in all directions;
• Ideal for rebar pulls, recovery and structural reinforcement;
• Does not create tension in the concrete, which allows for smaller distances between fixings;
• Uses specific Walsywa applicator for 600 ml;
• The packaging can be reused by changing the mixing nozzle;
• High resistance to chemicals and bad weather.

• Structural reinforcements;
• Structural recovery;
• Consoles;
• Pull-outs;
• Diaphragm wall;
• Fixing anchor bars;
• Fixing of stairs, railings and gates.

Image01: Qualifications Threaded Rod

Image02: Rebar

Image03: Solid

Image04: Fissured

Image05: Cured

Image06 Dry Hole

Image07 Humid Hole

Image08 Underwater Hole

Image09 Reverse Application

Image10 Conventional Hole

Image01: Methods of application on solid foundations (concrete, solid masonry and natural stone) 1 Drill the hole with the indicated diameter and depth;

Image02: 2 Inject air to remove excess powder from the hole;

Image03: 3 Thoroughly clean the hole with the aid of a brush, blow and brush until there is no more dust;

Image04: 4 Insert the mixing nozzle into the hole and fill ¾ of the total with resin;

Image05: 5 Insert the stud with a twisting motion;

Image06 6 Wait for the curing time recommended in the table;

Image07 7 After curing, position the element to be fixed and torque.

Fixing threaded rods

Rebar fixing

*Last resin load in 20 Mpa concrete. Values obtained together with the parameters described in the respective tables. For practical applications a safety factor must be used (see page 49).

** Number of applications per tube under ideal installation conditions.

• “Handling time” is the time in which it is possible to manipulate the product after mixing;

• “Curing time” is the time when the resin “dries” completely and is able to receive loads;

• Pullout tests must be done 24 hours after the final curing time;
• After curing, keep at room temperature up to 40°C;

• Do not cut the mixing nozzle;
• Clean the hole correctly as explained in the solid base application method;
• At the time of application, the tube must have a temperature within the limits of 5°C to 25°C;
• Do not apply the product to holes drilled with a diamond hole saw. For this application, use the WQE 500 or WQE 500 Plus anchor bolts;

• Any questions please contact the technical department on 0800 105024.